What is the proper way to use a Dick Nite?

A place for readers to talk about river fishing in Washington.
Forum rules
Forum Post Guidelines: This Forum is rated “Family Friendly”. Civil discussions are encouraged and welcomed. Name calling, negative, harassing, or threatening comments will be removed and may result in suspension or IP Ban without notice. Please refer to the Terms of Service and Forum Guidelines post for more information. Thank you
caseyweed
Angler
Posts: 7
Joined: Thu Aug 23, 2007 11:57 pm
Location: Bothell, WA
Contact:

What is the proper way to use a Dick Nite?

Post by caseyweed » Tue Oct 02, 2007 9:57 am

I see the illustration on their website, but I don't quite get it. I have it with the sliding drop weight and about a 3' leader. Now do you cast it and just let it coast down the river or do you start to retrieve it after it sinks for a few seconds. I'm fishing from shore if that makes a difference.

User avatar
lskiles
Commander
Posts: 395
Joined: Fri Jul 27, 2007 9:51 am
Location: Vancouver, USA

RE:What is the proper way to use a Dick Nite?

Post by lskiles » Tue Oct 02, 2007 11:20 am

Hey Caseyweed,

I did not know much about the whole Dick Nite thing, BUT there are threads on this River Fishing forum:
"Working A Spoon"
"leaders and droppers rule of thumb"

that have given me a better understanding of just how to work that Dick Nite or a spoon. You should check them out and if nothing else they may prompt more questions. I find it is much better to have questions in front of the computer where I can get an answer than to have them on the water where I have to just guess what the best thing would be to do and maybe not catch as many fish.
Hope that helps,
Lewis
Last edited by Anonymous on Tue Oct 02, 2007 11:24 am, edited 1 time in total.

User avatar
mallard83
Commodore
Posts: 928
Joined: Wed May 30, 2007 5:47 pm
Location: Bothell

RE:What is the proper way to use a Dick Nite?

Post by mallard83 » Tue Oct 02, 2007 6:06 pm

It sounds to me that you have the right setup as per what you described. The proper way to work a Dick Nite is to cast it out slightly upstream (depending on current speed) and as it drfts down stream, reel it slowly back (don't just drift it). Wait until the weight hits bottom then reel slow and steady. Dick Nites will out produce all other lures for silvers in the river if presented properly.

Oh, by the way I use a half ounce bank or ball sinker with about an 8" dropper.
Last edited by Anonymous on Tue Oct 02, 2007 6:08 pm, edited 1 time in total.

User avatar
noclothes1
Lieutenant
Posts: 228
Joined: Tue May 01, 2007 1:10 pm
Location: Bellingham

RE:What is the proper way to use a Dick Nite?

Post by noclothes1 » Tue Oct 02, 2007 7:58 pm

What size dick nite? I have a few #2's and #1's. Is color dependant on water and sky conditions?
"It's the failure that keeps me coming back"

User avatar
mallard83
Commodore
Posts: 928
Joined: Wed May 30, 2007 5:47 pm
Location: Bothell

RE:What is the proper way to use a Dick Nite?

Post by mallard83 » Tue Oct 02, 2007 8:07 pm

noclothes1 wrote:What size dick nite? I have a few #2's and #1's. Is color dependant on water and sky conditions?
I don't really pay to much attention as to what size (i.e. number). I just know that the "Wee" size is the smallest size they make and I use that size and the next size up for silvers and humpies. The 50/50 color that I mentioned is the best all around color for any condition, unless the river is blown out (unfishable) or real dirty then it is better to use eggs. Other colors will work, but 50/50 is the best. I can check on some of my unopened Dick Nites and check exactly what size they are if you would like.

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Tue Oct 02, 2007 9:12 pm

Smallest aka "Wee" size = 0
One size up= 1
One mre size up = 2
Don't chase reports...Be the report others chase....

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:What is the proper way to use a Dick Nite?

Post by EdmondsBassMan » Wed Oct 03, 2007 12:10 am

I'm pretty new to the whole salmon fishing thing but I use a snap swivel tied to my main line where I can then attach a slinky weight(3/4 to 1oz) with anywhere from a 2 to 5 foot leader. I have caught several fish that way. I would have to agree with the 50/50 being one of the most productive color as well.
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

LM
Petty Officer
Posts: 19
Joined: Tue Oct 02, 2007 10:50 am
Location: auburn/enumclaw

RE:What is the proper way to use a Dick Nite?

Post by LM » Sat Oct 06, 2007 5:05 pm

i checked couple of places and cant find a 50/50...must be a shortage for some reason:colors:

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Sat Oct 06, 2007 9:52 pm

Yea I worked at a tackle shop up until early september and we couldn't keep any pink or 50 50 dick nites in...Guys would come and see us restock the shelves and would pull em all off and buy them, somtimes as many as like 50 or 60
Don't chase reports...Be the report others chase....

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:What is the proper way to use a Dick Nite?

Post by EdmondsBassMan » Sat Oct 06, 2007 10:07 pm

SHHHHHH don't tell anyone but try Fred Meyer I have found a good selection there sometimes!
Last edited by Anonymous on Sat Oct 06, 2007 10:10 pm, edited 1 time in total.
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:What is the proper way to use a Dick Nite?

Post by EdmondsBassMan » Sat Oct 06, 2007 10:10 pm

Oh yeah I have a question when using the WEE size do you use a snap swivel or tie the leader directly to the little ring? The bigger ones have an attached swivel so I was using a snap swivel for the 1s and 0s.
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Sat Oct 06, 2007 10:35 pm

Nah stick away from the snap swivels and tie your leader right to that ring.
Don't chase reports...Be the report others chase....

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:What is the proper way to use a Dick Nite?

Post by EdmondsBassMan » Sat Oct 06, 2007 10:53 pm

Thanks again Sam! boy with all the info you have shared with me I think I owe you a coffee or something!LOL I really appreciate it!
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Sat Oct 06, 2007 11:03 pm

No problem. Everyone has questions when engaging in a new type of fishing and it always feels good to be able to help people out, because we all started from scratch and had questions at first...So it's nice to be able to return the favor...
Don't chase reports...Be the report others chase....

User avatar
noclothes1
Lieutenant
Posts: 228
Joined: Tue May 01, 2007 1:10 pm
Location: Bellingham

RE:What is the proper way to use a Dick Nite?

Post by noclothes1 » Sun Oct 07, 2007 10:54 am

Has anybody ever fished a dick nite under a float? For some reason I'm obsessed with float fishing.

Also, do you ever tip the hook on a Dick nite with a single egg?

I agree, Sam has also taught me many things as well.
"It's the failure that keeps me coming back"

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Sun Oct 07, 2007 2:00 pm

I can't imagine that a Dick Nite could be float fished. It would just hang there and would have no action, but if it was pink and found its way in the face of some humpy's, it might get hits..

I've never tipped DN's either. Or any spoons for that matter. It takes away the action, so I have to use scents such as Smelly Jelly when using spoons...
Don't chase reports...Be the report others chase....

User avatar
noclothes1
Lieutenant
Posts: 228
Joined: Tue May 01, 2007 1:10 pm
Location: Bellingham

RE:What is the proper way to use a Dick Nite?

Post by noclothes1 » Sun Oct 07, 2007 3:17 pm

Yeah I figured the action would be affected.

But what if you rigged the DN under a float in like a reverse bottom bouncing rig? go Bobber - egg weight - swivel - leader - DN. I supposed the float would drift too fast and get ahead of te DN not allowing it to get horizontal.....
"It's the failure that keeps me coming back"

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:What is the proper way to use a Dick Nite?

Post by A9 » Sun Oct 07, 2007 5:33 pm

The float would likely drift the same speed as the dick nite, thus being completely vertical and having no action...
Don't chase reports...Be the report others chase....

LM
Petty Officer
Posts: 19
Joined: Tue Oct 02, 2007 10:50 am
Location: auburn/enumclaw

RE:What is the proper way to use a Dick Nite?

Post by LM » Fri Oct 19, 2007 12:30 pm

if any of you looking for the 50/50 in the wee size still and is in the federal way area head over to boat world( i think that the name)by bestbuy...i pick up a few yesterday there...

i never been there before

User avatar
jake campbell
Petty Officer
Posts: 90
Joined: Thu May 17, 2007 5:00 pm
Location: Arlington

RE:What is the proper way to use a Dick Nite?

Post by jake campbell » Fri Oct 19, 2007 7:44 pm

I let the dick nite sink down for a three second count, then slowly retrieve it giving it a nice wobling action.

Post Reply